Re: hard starting

[Slim <falzsf@home.com>]

Well I would start at you Cold start valve. It is located on your intake
manifold. ON the left side when facing the car from the front.  It should be
getting 12 V whilee you car is being turned over. The thermo time switch
controls it and it is located on the upper rad hose where it goes from rubber to
a metall tube into your head (confusing). Located on the top as their is a few
sensors on it. Using a ohmmeter measure the sensor it should read 0.5ohms or
less when the car is cold. Few, better yet check the BENTLY! Heh


Casey Webster wrote:

> I'm having a little trouble starting my car when it's cold.  It will just
> keep turning over and over and over for about 15 seconds before it will
> finally start, and even then it takes a few more seconds to get the idle up
> to normal.  With the cold temperatures and all, would having a cam or any
> other mods cause this rough starting?  Loose belts?
>
> Casey
> 84 wolfsburg roc
>
> BTW I'm putting the car away this weekend, so I have all winter to figure it
> out I guess
>
> --
> Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
> "unsubscribe scirocco-l" in the message to majordomo@scirocco.org


--
Email problems to: scirocco-l-probs@scirocco.org  To unsubscibe send
"unsubscribe scirocco-l" in the message to majordomo@scirocco.org