Re: Sway bar clamps

[Roccet@aol.com]

In a message dated 4/7/99 11:03:47 PM Pacific Daylight Time, 
feenix@javanet.com writes:

<< I don't remember, but I was one of the ones who busted a bracket. Went
 to a machine shop and they told me aluminum wouldn't be any good either.
 Anyway they custom made two out of a thicker steel and thus far (knock
 on wood) they have held up. Even to my severe cornering habits.
 
 Feenix...
 88 16V
  >>
Well i dont know what to tell you but i promise these will  not  break. i 
will replace them if for some reason they did. i have sold over 100 sets 
going on 200 sets of brackets, i know of 5 sets used in pro rally off road . 
i have NEVER replaced a set yet... these have been installed for over a year 
and a half. if  i did end up having a problem i would start making them out 
of stainless but same design as i mfg now. the cost would be more but i would 
still gaurantee them..

--
To unsubscribe, send "unsubscribe scirocco-l" to majordomo@scirocco.org.
If you experience other problems, email: scirocco-l-probs@scirocco.org