RE: Autotech Swaybar

[Brian Honnold <bhonnold@pac-cap.com>]

OUCH!!!!!

$54 for a couple of aluminum blocks with holes drilled in it.  I paid less than that for both swaybars!!!

Anyone out there do any machining work on the side???

Brian Honnold
'78 Rocco Ragtop

On Wednesday, September 02, 1998 10:12 AM, Aaron D. Patton [SMTP:apatton1@airmail.net] wrote:
> The real solution is to go here:
> http://www.spiretech.com/~vw6spd/products.html.  This is the performance
> products section of the VL Enterprises web page,  towards the bottom you
> will see the billet sway bar mounts.
> Aaron
> -----Original Message-----
> From: Brian Honnold <bhonnold@pac-cap.com>
> To: scirocco-L@scirocco.org <scirocco-L@scirocco.org>
> Date: Wednesday, September 02, 1998 12:12 PM
> Subject: RE: Autotech Swaybar
> 
> 
> >Which brackets are breaking?  I'm about to put on the 22mm front, 25mm rear
> >and the lower subframe.  I don't have the front mounts yet though so if
> >those are the ones that break what is the solution.?
> >
> >Brian Honnold
> >'78 Rocco Ragtop
> >
> >On Wednesday, September 02, 1998 5:32 AM, Brett VanSprewenburg
> >[SMTP:brett@kodak.com] wrote:
> >>
> >> >
> >> > Anyone have one of these? I looking at getting a 22mm for my 87 16V. I
> >remember
> >> > some time back a thread was going around about them breaking brackets.
> >If so
> >> > how was this resolved? Thanks guys!
> >> >
> >> > Thank You for Your Time, and soon to kicking ass in ES!
> >> >         Shannon Fenton
> >> >             Ext. 2712
> >>
> >> Yes, I've got the Autotech bars on my car, 22mm front, 25mm back.  I've
> >> broken 3 brackets so far, 2 stock and one of the HD SS Autotech brackets.
> >> I would suggest getting some of those _really_ heavy duty units machined
> >> from solid blocks of metal.  I think VL Enterprises makes/has this, check
> >> their web pages (probably a link on scirocco.org).  I'll be buying them
> >> myself at some point.
> >>
> >> ==Brett
> >> --
> >> To subscribe or unsubscribe, send email to
> >scirocco-L-request@scirocco.org,
> >> with your request (subscribe, unsubscribe) in the BODY of the message.
> >>
> >--
> >To subscribe or unsubscribe, send email to scirocco-L-request@scirocco.org,
> >with your request (subscribe, unsubscribe) in the BODY of the message.
> >
- --
To subscribe or unsubscribe, send email to scirocco-L-request@scirocco.org,
with your request (subscribe, unsubscribe) in the BODY of the message.

------------------------------