[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Question about timing hole plug on the tranny...
- Subject: Re: Question about timing hole plug on the tranny...
- From: "Wm. Josiah Erikson" <josiah@gsinet.net>
- Date: Sat, 10 Oct 1998 16:44:45 -0400
The draining plug at the bottom of the tranny is 17mm... is that what you mean?
-Josiah
http://www.gsinet.net/~josiah
Anthony Pelletier wrote:
> Date: Fri, 09 Oct 1998 14:40:02 -0400
> To: Ilias Glavinas <elias@tesla.wustl.edu>
> From: "John C. Worden" <scirocco@midmaine.com>
> Subject: Re: Question about timing hole plug on the tranny...
> Cc: scirocco-l@scirocco.org
>
> At 12:28 PM 10/8/98 -0500, Ilias Glavinas wrote:
>
> I bought a 27mm allen socket at a local forign auto store for like $7
> it works great and you can also use it for the draing plug at the
> bottom of the tranny(which is what I bought it for)
> later
> Tony
>
> >
>
> >I have an 85. The f&(*&# green fluorescent plug on the tranny will simply
> >not come out (I have even started to chip it by trying to take it off).
> >
> >Luckily I have another plug from my (now dead) 9A tranny, however, I
> >still have to take the other plug off, and I could by totally destroying
> >it but then the pieces will fall inside the clutch area.
> >
> >I have decided to break down and buy a huge allen wrench to remove it.
> >
> I had this problem too. Here's what I did(and it was cheaper too). Buy a
> bolt that has a head the size of the allen wrench you were going to buy.
> Get one that is 3" or 4" long, and get the nut too. Then weld the nut to
> the end of the bolt, or if you don't have access to a welder drill a hole
> through the nut and bolt and put in a roll pin. Then put the one end into
> the plug and with an ajustable wrench on the other it will come out. I put
> anti-sieze on it after it came out. Works good and will save you a few
> bucks too.
>
> John '98 Dak cc Sport 4x4, 3.9 auto, Intense Blue, Leer Classic tonneau,
> Pioneer DEH-P85DHR, ventshades, headlight/tailight covers,
> penda liner
> '84 Scirocco (under construction) Brakes and Suspension currently
> '69 MGB Roadster(in need of restoration)
> --
> To subscribe or unsubscribe, send email to scirocco-L-request@scirocco.org,
> with your request (subscribe, unsubscribe) in the BODY of the message.
>
> --
> To subscribe or unsubscribe, send email to scirocco-L-request@scirocco.org,
> with your request (subscribe, unsubscribe) in the BODY of the message.
- --
To subscribe or unsubscribe, send email to scirocco-L-request@scirocco.org,
with your request (subscribe, unsubscribe) in the BODY of the message.
------------------------------