Re:

[Night Shadow <soltwede@ucsub.Colorado.EDU>]

On Fri, 6 Nov 1998, Shawn C Meze wrote:

> Changing the bearings:
> Not too hard, just be sure you have adequate jack stands. Stacking
> plywood just doesn't seem to cut it. (Right Eric? DOH!!) 

It wasn't the jackstands, it was those damn cheap hydrolic jacks....
Definately need to be careful....especially when jerry-rigging is
involved!

:-)~

> You will need the special tool, although you could just take the whole
> thing to a machine shop and have them press out the old, and press in the
> new bearings. ($$) 

I would opt for this, after using that tool, taking the stuff to a machine
shop would have been TONS easier!

Eric



--
To subscribe or unsubscribe, send email to scirocco-L-request@scirocco.org,
with your request (subscribe, unsubscribe) in the BODY of the message.