Re: Busted oil cooler

[TBerk16@aol.com]

In a message dated 12/4/98 8:53:47 AM Pacific Standard Time, emt@imcnyc.com
writes:

> 
>  I heard that one from a Digifant might be good.
>  
>  
>  I have gone through three oil coolers in about six years.  The cost to 
> replace is not a big deal....
>  but, it is a damn mess with oil everywhere except where it is supposed to
be.
>   I have used
>  Autotech and Neuspeed.  No problems with the sandwich or connections but
the 
> cooler itself
>  doesnt seem to be able to hold up in my 2.1.  I run a heavy duty oil pump 
> that puts out around
>  80lb at start up and settles to 30lb at idle when at running temp.  Any 
> ideas or suggestions?
>  
>  Dale
>  82 2.1 16v rocco (Zender 400 w/NOS)
>  86.5 2.0 16v rocco
>  
>  
Pricey but you might look into aircraft parts. Not ness. for the entire system
but just for the prone to failure portions.

Other brainstorm was if there was some form of pressure regulator but Hah, I'm
just sleep deprived.

hth,
TBerk

--
To subscribe or unsubscribe, send email to scirocco-L-request@scirocco.org,
with your request (subscribe, unsubscribe) in the BODY of the message.