[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Pax side motor mount change
- Subject: Re: Pax side motor mount change
- From: TBerk16@aol.com
- Date: Tue, 25 Aug 1998 02:05:46 EDT
In a message dated 8/24/98 8:20:01 AM Pacific Daylight Time, galecki@umr.edu
writes:
> I
> noticed the Techtonics catalog has the mount pressed into the bracket
> already. Is this bracket hidden by the timing belt cover??? Any special
> tools other than a press needed for this job? The shop quoted me about $115
> for that mount alone so I would really like to do it myself.
>
> TIA,
> __Wojciech Galecki__
> '84 vibrating 8v
Great Idea doing as much of your own work as possible. Two things I have run
across:
1. One guy said he cut the old rubber unit out w/ a hacksaw. Don't cut the
bracket! Then he put the metal bracket in the oven and the new rubber bushing
in the freezer to cool down. With hammer and a board to spread out the impact,
he whacked and whacked until it was pressed in. YMMV.
2. On the other hand; the Potterman will send you one already pressed in to a
bracket f you send him the old one- A refundable deposit will apply if you
need the new one before you take the old one out. (Minimal downtime).
hth,
TBerk
--
To subscribe or unsubscribe, send email to scirocco-L-request@scirocco.org,
with your request (subscribe, unsubscribe) in the BODY of the message.
------------------------------