[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: reverse light/tranny swap



What I would do in this situation is just use the several-pin style connector
(get one from somewhere) and connect the right wires into your wiring harness
in the car. Get an ohmmeter and find out what two wires get connected together
when you put the car in reverse, and then you'll be all set. Just connect those
two wires to the two wires that went to the other style switch.
    I'm sure there are other ways to do it, too.
    -Josiah

POTATO! wrote:

> hi...i'm mating up an 83 8v gti tranny to a 16v engine..but it has the
> newer style reverse light switch (black plastic with several plastic pins
> in it)...but the car it is goin into has the older style switch set up (2
> prongs on a swithc that screwed into the transmission)..has anyone dealt
> with this type of conversion?.....is it as simmple as snaggin the switch
> that goes to the new tranny and connecting the correct wires?
>
> any help would be appreciated..
>
> thanks
> Dave
>
> --
> To subscribe or unsubscribe, send email to scirocco-L-request@scirocco.org,
> with your request (subscribe, unsubscribe) in the BODY of the message.



--
To subscribe or unsubscribe, send email to scirocco-L-request@scirocco.org,
with your request (subscribe, unsubscribe) in the BODY of the message.

------------------------------