Re: shift bushings and gear selector alignment

["Owen" <rabeys@cadvision.com>]

> Yes... you know those little rods with white plastic ends that are in
your original
> shift linkage? They snap onto little metal balls... those metal balls are
supposed
> to have those little disks under them. That's why there's a hole in the
middle- so
> you can slide them down over the balls.

	Any idea about the small black cylinder shaped bushings.  the dumbest way
i can describe them is they look like a little black top hat, with the top
cut off

		Aligning the linkage doesn't sound too hard.  

			thanks for the tips.

Owen
87 16v
http://www.geocities.com/MotorCity/Garage/1571
--
To subscribe or unsubscribe, send email to scirocco-L-request@scirocco.org,
with your request (subscribe, unsubscribe) in the BODY of the message.

------------------------------