[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Fwd: Changing Idle Speed....????
In a message dated 97-04-18 10:14:39 EDT, MAINElyVW1 writes:
<< Subj: Re: Changing Idle Speed....????
Date: 97-04-18 10:14:39 EDT
From: MAINElyVW1
To: hjowett@nasc.mass.edu
CC: eudoh@crl.com, rts@phoenix.net
CC: tim@surrealsoft.com, scirocco-l@privatei.com
If your useing a dutycycle meter set it at 50%. If you have a enrichment
switch....after setting the duty cycle if you hold the switch with your
finger the meter should read 65%. If you take the wire from the O2 sensor and
fround it the meter will enrichen or try to go 95%. If you take a d battery
and groung the negative side to the manifold and put the O2 wire on positive
the the meter will fall to 5% leaning the car out. If you don't have a duty
meter use a dwell meter on 4 cyl scale the the set will be 45 then. The test
connection is by the coldstart valve or the coil depending on your cars year.
Steve T
MAINElyVW1@aol.com
84 Scirocco GTX
88 Fox
Mainely Metric >>
---------------------
Forwarded message:
Subj: Re: Changing Idle Speed....????
Date: 97-04-18 10:14:39 EDT
From: MAINElyVW1
To: hjowett@nasc.mass.edu
CC: eudoh@crl.com,rts@phoenix.net
CC: tim@surrealsoft.com
CC: scirocco-l@privatei.com
If your useing a dutycycle meter set it at 50%. If you have a enrichment
switch....after setting the duty cycle if you hold the switch with your
finger the meter should read 65%. If you take the wire from the O2 sensor and
fround it the meter will enrichen or try to go 95%. If you take a d battery
and groung the negative side to the manifold and put the O2 wire on positive
the the meter will fall to 5% leaning the car out. If you don't have a duty
meter use a dwell meter on 4 cyl scale the the set will be 45 then. The test
connection is by the coldstart valve or the coil depending on your cars year.
Steve T
MAINElyVW1@aol.com
84 Scirocco GTX
88 Fox
Mainely Metric
--
To subscribe or unsubscribe, send email to scirocco-L-request@privateI.com,
with your request (subscribe, unsubscribe) in the BODY of the message.